The Blind Mark: Problem and Solution

The Problem and the Solution

The Problem
Cutting out access holes in drywall costs do-it-yourselfers time and money!
One wrong measurement can ruin an entire piece of drywall (not to mention all the time spent putting it up and taking it down!). DIYer’s not skilled with the use of a rotary cutter can end up cutting too large of a hole.

The Solution: The Blind Mark
The Blind Mark drywall tool gives you the comfort of knowing the location of the box under the drywall before you start cutting. The electrical box can be found in a matter of seconds, replacing all of the time that is spent measuring in typical drywall installation. The Blind Mark allows consumers the ability to cut with a multitude of drywall tools, both hand and electric and eliminates the possibility of making a bad measurement!

Using the Tape Measure
1) Measure X
2) Write down X measurement
3) Measure Y
4) Write down Y measurement
5) Put up drywall sheet
6) Measure and mark X
7) Measure and mark Y
8) Cut out access hole

Using the Blind Mark
1) Insert Blind Mark Target
2) Put up drywall sheet
3) Locate Target with Blind Mark and remove target

This allows you to do more in less time, and in this business ... Time is Money!

Without the Blind Mark, cuts can be messy.

With the Blind Mark, cuts come out perfect every time.