Step 1
Compare the Multi Mark™ locator to the outside perimeter of the electrical box you are using. Electrical boxes vary so this will show you where to make your cut(on the line inside or outside the line).

Place Multi Mark™ target in electrical box inserting the ends of the springs into the electrical box device locating holes. Take a mental note as to the direction of the arrow. If you have a multi-gang box you install the targets at each end of the box.

With the Multi Mark™ target installed in the electrical box, cover the box up with the drywall. Position your drywall in the exact location and fasten with enough screws to safely secure the drywall.

With the arrow on the Multi Mark™ locator facing in the same direction as Multi Mark™ target, pass the locator across the area in which the target is located. The locator will find the target and snap in place. Do not force the locator into position. Then using the appropriate template, use your pencil to mark around the locator, outlining the electrical box perimeter.

Remove the locator from the drywall. Cut out the drywall using your mark as a guide. If you are using a hand saw, keep in mind, the cut on the side where the stud is must be a shallow cut. Multiple tools can then be used (hand or electric) to cut the drywall.

Step 5

Remove the drywall cut out and Multi Mark™ target. Note: When removing the Multi Mark™ target use two hands, holding each end of the spring pull straight out. Finish screwing down the drywall. And you’re Done!!!